LASER NEWS

1. There is no laser output suddenly during the working process, and the re-marking software displays "IPG system failure"Answer: 1) The processing material does not belong to the high-reflection material: replace the laser with another marking table that is confirmed to be normal for testing. If th

Common faults and solutions of Raycus medium and high power lasersLaser does not power up1.1 Please turn off the air switch of the laser and check the external power supply to ensure that the laser model is consistent with the instruction manual and the wiring is correct.1.2 Please turn on the air s

Common faults of BM111 laser headWhen the BM111 laser head is used, the driver reports C90 abnormality when returning to zero or jogging?If the encoder cable is connected normally, the abnormality is probably caused by external interference. You can connect the power supply of the drive to the power

Common problems of laser cuttingBurrs appear on the edge of the workpiece during laser cutting:When laser cutting carbon steel, burrs sometimes appear on the edge of the workpiece, making the surface not smooth, and some are difficult to remove, mainly due to the following points:1. The upper and lo