Common faults of BM111 laser headWhen the BM111 laser head is used, the driver reports C90 abnormality when returning to zero or jogging?If the encoder cable is connected normally, the abnormality is probably caused by external interference. You can connect the power supply of the drive to the power
Common problems of laser cuttingBurrs appear on the edge of the workpiece during laser cutting:When laser cutting carbon steel, burrs sometimes appear on the edge of the workpiece, making the surface not smooth, and some are difficult to remove, mainly due to the following points:1. The upper and lo
The laser cutting machine mainly uses a laser beam to irradiate the surface and release energy to see the steel plate melt and evaporate. Because of the high concentration of energy, rapid local melting and heating can be performed to evaporate the steel plate. Due to the high concentration of energ
Laser cutting perforation technology:Any thermal cutting technique, except in a few cases where it can start from the edge of the board, generally has to make a small hole in the board. Earlier, on the laser stamping compound machine, a punch was used to punch a hole, and then a laser was used to st